C1 Release Notes Current Version: V1.4.0.0 [Notes] C1 V1.4.0.0 must work with N9 V2.3.0.0. [New Features] 1. Supports AUX follow preset switching. 2. Supports AUX follow screen FTB. 3. Supports AUX scaling, including full screen and proportional. 4. Supports two AUX connector mosaic on the N9. 5. Supports AUX control of the VE7 on the N9. 6. Supports controlling multiple N9 units on the C1. 7. Displays the diagnostic result and provides a debugging connector. 8. Supports both standard and custom EDID settings (up to 4096x2160@60Hz) on DP 1.2 input connector. 8. Supports up to 4096-pixel width or height for custom output resolution. 10. Supports auto searching and connecting of the N9 units after the Ethernet connection between the C1/V-Can and N9 is completed. (When the C1 is connected with one single device, auto searching, adding and connecting are all supported. When the C1 is connected with multiple devices, only auto searching is supported.) 11. Supports checking the N9 and VE7 versions on the C1/V-Can for you to quickly find out which versions of the devices are running. 12. Supports preset importing and exporting. 13. Supports individual adjustment of R, G and B colors of the J6. 14. Supports layer border settings of the J6 no matter the device is in Splicer or Switcher mode and no matter on PGM or PVW. [Improvements] 1. Optimized FTB function, including turning on or off FTB and FTB duration settings. 2. Optimized handling mechanism when the device is disconnected with the control PC. 3. Optimized test pattern function. The test pattern will not be closed after you exit the test pattern, and will be closed when you set the test pattern to Normal.